Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 008-180 — Xerox Phaser 7760

Code: 008-180

Description: Duplex Registration Sensor On Jam The Registration Sensor does not detect paper after a duplex feed.
Remedy: Open the Left Cover Assembly (PL 2.9). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Block and unblock the Registration Sensor (PL 2.6). The display changes state. Y↓N→Check the circuit of the Registration Sensor. Refer to Reflective Sensor Procedure for troubleshooting procedure. Close the Left Cover Assembly and remove the Left Upper Cover (PL 2.7). Perform Duplex Motor test. The Duplex Transport Roll (PL 12.1) rotates. Y↓N→The Duplex Motor (PL 12.1) energizes. Y↓N→Check the circuit of the Duplex Motor. Refer to OF 99-6 RAP for troubleshooting procedure. Check the Duplex Motor and its associated pulleys and belts for damage, contamination or misalignment. Perform Service Diagnostics. The Inverter Reverse Clutch energizes. Y↓N→Check the circuit of the Inverter Reverse Clutch. Refer to OF 99-4 RAP for troubleshooting procedure. Perform Service Diagnostics. The Duplex Gate Solenoid energizes. Y↓N→Check the circuit of the Duplex Gate Solenoid. Refer to OF 99-4 RAP for troubleshooting procedure. • Check that the Duplex Chute (PL 2.8) is properly seated and not damaged. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If the problem persists, replace the Duplex PWB (PL 12.1). Y↓N→Check the circuit of the Duplex Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Duplex Motor and its associated pulleys and belts for damage, contamination and misalignment. • Check the Duplex Wait Roll and Pinch Rolls for damage and contamination. • Ensure that the connectors shown in circuit diagrams ( ) are securely connected and that the wires are not damaged. • Ensure that the Duplex Chute (PL 2.8) is properly seated and not damaged. • If the problem persists, replace the Duplex PWB.

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie