Description: Registration Sensor Off Jam The Fuser Exit Switch did not detect paper after the Registration Clutch was energized.
Remedy: Open the Left Cover Assembly (PL 2.9). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Fuser Exit Switch (PL 2.8). The display changes state. Y↓N→Check the circuit of the Fuser Exit Switch. Refer to OF 99-3 RAP for troubleshooting procedure. Perform the Registration Clutch test. The Registration Clutch (PL 2.6) energizes. Y↓N→Check the circuit of the Registration Clutch. Refer to OF 99-4 RAP for troubleshooting procedure. Close the Left Cover Assembly. Perform the 2nd BTR Retract Motor test. The 2nd BTR Retract Motor (PL 2.9) energizes. Y↓N→Refer to RAP 009-342, 009-343, 2nd Contact or Retract Failure troubleshooting procedure. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If the problem persists, replace the Duplex PWB (PL 12.1).