Description: Unexpected IBT Home Sensor Signal The IBT Home Sensor detected the IBT position strip before the IBT Belt made a complete revolution.
Remedy: 1 1. Remove the Accumulator Belt Assembly. 2. Inspect the DTS Connector for damage. 3. Is the connector damaged? Replace the Accumulator Belt Assembly. Go to step 2. 2 Is the mating connector inside the printer damaged? Repair or replace the wiring harness between J605 and the Connector. Go to step 3. 3 1. Reinstall the Accumulator Belt Assembly. 2. Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Run the Accumulator MOB Sensor test. 3. Is the value H when the Belt Home Marker is NOT under the Belt Home Sensor? Refer to Reflective Sensor Procedure. Replace the following order: 1. Engine Control Interface Board 2. Engine Control Board (MCU PWB)