Description: Accumulator Belt Drive Logic Fail The IBT Edge Sensor detected that the IBT Belt is not tracking correctly.
Remedy: 1 1. Remove the Accumulator Belt Assembly. 2. Inspect the DTS Connector for damage. 3. Is the connector damaged? Replace the Accumulator Belt Assembly. Go to step 2. 2 Is the Edge Sensor Actuator touching the Belt? Replace the Accumulator Belt Assembly. Go to step 3. 3 Is the mating connector inside the printer damaged? Repair or replace the wiring harness between the connector and J605. Go to step 4. 4 1. Reinstall the Accumulator Belt Assembly. 2. Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Run the Belt Edge Sensor test. 3. Is the result OK? Go to step 5. Run the Belt Edge Learn and recheck. If it still fails, go to step 8. 5 1. Switch the printer power On. 2. Remove the Rear Cover. 3. Measure the voltage between the Engine Control Interface Board and J539A3(+) and frame ground. 4. Does the voltage measure between +1 to +3 VDC? Go to step 8. Go to step 6. 6 1. Measure the voltage between the Engine Control Interface Board and J539A-1 and frame ground. 2. Does the voltage measure +5 VDC? Go to step 7. Replace in the following order: 1. Engine Control Interface Board 2. Engine Control Board (MCU PWB) 7 1. Measure the voltage between the Engine Control Interface Board and J539A-2 and frame ground. 2. Does the voltage measure +5 VDC? Replace in the following order: 1. Engine Control Interface Board 2. Engine Control Board (MCU PWB) The Edge Sensor is defective, replace the Accumulator Belt Assembly. 8 1. Remove the Accumulator Belt Assembly. 2. Enter Service Diagnostics and run the Steering Motor test. 3. Does the Motor turn? Replace the Accumulator Belt Assembly. If the problem is unresolved, replace the Engine Control Board (MCU PWB). Go to step 9. 9 1. Measure the voltage between the Engine Control Interface Board J537-6 and frame ground. 2. Is the voltage +24 VDC? Go to step 10. Replace in the following order: 1. Engine Control Interface Board 2. Engine Control Board (MCU PWB) 10 1. Measure the voltage between the Engine Control Interface Board J537 Pins 2, 3, 4, 5 and frame ground. 2. Is the voltage +24 VDC? Replace in the following order: 1. Engine Control Interface Board 2. Engine Control Board (MCU PWB) Replace the Steering Drive Assembly.