Description: Y, M, C, K ATC Sensor Fail The ATC Sensor detects an insufficient amount of Developer. This procedure can be used for troubleshooting Chain Link code 009-380, 009-381, 009-382, or 009-383. NOTE: If this failure reoccurs three times successively, an Engine NVRAM value is set preventing further printer use until the Clear Tech Rep Faults () is performed.
Remedy: 1 Is the problem toner and/or Developer empty? Replace the Tone or Developer. Go to step 2. 2 Is the ATC Sensor clean and free of dust, toner, or any other contaminates? Go to step 3. Clean the ATC Sensor. 3 1. Check the ATC Sensor wiring harness: • Yellow = P/J129 • Magenta = P/J130 • Cyan = P/J131 • Black = P/J132 2. Is the wiring harness or the sensor defective? Replace the ATC Sensor and/or wiring harness. Go to step 4. 4 1. Remove the Rear Cover. 2. Measure the voltage on the Engine Control Board at: • Yellow = P401B3 • Magenta = P401B8 • Cyan = P401A10 3. Is the voltage between +1 and +3 VDC? Replace the Engine Control Board (MCU PWB). Go to step 5. 5 1. Measure the voltage on the Engine Control Board at: • Yellow = P401B14 • Magenta = P401B11 • Cyan = P401A11 2. Is the voltage +5 VDC? Replace the Engine Control Board (MCU PWB). Go to step 6. 6 1. Measure the voltage on the Engine Control Board at: • Yellow = P405B2 • Magenta = P405B9 • Cyan - P405A9 2. Is the voltage 0 VDC? Replace the Engine Control Board (MCU PWB). Go go step 7. 7 1. Remove the Imaging Unit Plate Cover. 2. Inspect the wiring harness between the Engine Control Board and the Developer Housing Assembly. 3. Is the wiring harness defective? Replace the wiring harness. Replace the ATC Sensor. 8 Run approximately 10 pages of the Solid Fill full-page prints for this color to ensure the error is cleared.