Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 009-413 — Xerox Phaser 7760

Code: 009-413

Description: Black Toner Cartridge Near Empty The Black Toner Cartridge is nearly empty. This fault requires service only if the message appears before the Toner Cartridge is depleted.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Run the Black Dispenser Motors test. The Black Toner Dispense Motor energizes (PL 6.1). Y↓N→There is +24 VDC from J406-9 to GND. Y↓N→Go to the +24 VDC Wirenets ( Wiring Data, +24 VDC Wirenets ) and troubleshoot the problem. There is +24 VDC from J406-8 to GND. Y↓N→Check the wires from J406 to J230 for an open circuit. If the wires are OK, replace the Cyan Toner Dispense Motor (PL 6.1). The voltage from J406-8 to GND drops to less than 1 VDC. Y↓N→Replace the Engine Control Board (MCU PWB) (PL 13.1). If the problem continues, replace the I/F PWB (PL 9.1). Check the wires from J406 to J230 for an open circuit. If the wires are OK, replace the Cyan Toner Dispense Motor (PL 6.1). Perform the Developer Motors test. The Black Developer Assembly energizes (PL 1.1). Y↓N→Check the mechanical drive to the Clutch, refer to BSD 4.1. Check the circuit of the Developer Clutch (K) (PL 1.2). Check ADJ 9.3. The Black ATC Sensor check is OK. Y↓N→Go to RAP 009-380, 009-381, 009-382, 009-383, ATC Sensor Failure. After checking that no failures are detected during normal operation, go to call closeout.

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie