Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-105 — Xerox Phaser 7760

Code: 010-105

Description: Fuser Exit Switch On Jam The Fuser Exit Switch did not actuate.
Remedy: Remove the Fuser Assembly from the machine and check Check the Fuser Stripper Fingers and Fuser Roll (PL 7.1) for dirt build up, wear or damage. The check is OK. Y↓N→Clean or replace the Fuser Assembly (PL 7.1). Open the Left Cover Assembly (PL 2.8). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Fuser Exit Switch (PL 2.8). The display changes state. Y↓N→Check the circuit of the Fuser Exit Switch. Refer to OF 99-3 RAP for troubleshooting procedure. Perform the Registration Clutch test. The Registration Clutch (PL 2.6) energizes. Y↓N→Check the circuit of the Registration Clutch. Refer to OF 99-4 RAP for troubleshooting procedure. Close the Left Cover Assembly. Perform the 2nd BTR Retract Motor test. The 2nd BTR Retract Motor (PL 2.9) contacts and retracts. Y↓N→Go to RAP 009-342, 009-343, Contact or Retract Failure procedure. • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • If the problem persists, replace the Engine Control Board (MCU PWB) (PL 13.1).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie