Code: 010-125
Description: Duplex Wait Sensor On Jam The Duplex Wait Sensor did not actuate.
Remedy: Make a 2 sided print. The first sided print is seen to partially exit and then move back into the Printer for side 2. Y↓N→Repair following as required: • Gate, linkage, and Gate Solenoid for binding Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Open the Duplex Module Cover and block and unblock the Duplex Wait Sensor. The display changes state. Y↓N→Check the circuit of the Duplex Wait Sensor. Refer to Reflective Sensor
for troubleshooting procedure. Remove the Left Upper Cover (PL 2.7). Perform the Duplex Motor test. The Duplex Transport Roll (PL 12.1) rotates. Y↓N→The Duplex Motor (PL 12.1) energizes. Y↓N→Check the circuit of the Duplex Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Duplex Motor and its associated pulleys and belts for damage, contamination and misalignment. Perform the Duplex Clutch test. The Inverter Forward Clutch (CW) energizes. Y↓N→Check the circuit of the Inverter Forward Clutch. Refer to OF 99-4 RAP for troubleshooting procedure. Perform the Duplex Clutch test. The Inverter Reverse Clutch (CCW) energizes. Y↓N→Check the circuit of the Inverter Reverse Clutch. Refer to OF 99-4 RAP for troubleshooting procedure. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If the 10-125 occurs when duplexing, there may be excessive clearance between the Tray Nip Solenoid arm and shaft. Refer to TAG F-001.
for troubleshooting procedure. Remove the Left Upper Cover (PL 2.7). Perform the Duplex Motor test. The Duplex Transport Roll (PL 12.1) rotates. Y↓N→The Duplex Motor (PL 12.1) energizes. Y↓N→Check the circuit of the Duplex Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Duplex Motor and its associated pulleys and belts for damage, contamination and misalignment. Perform the Duplex Clutch test. The Inverter Forward Clutch (CW) energizes. Y↓N→Check the circuit of the Inverter Forward Clutch. Refer to OF 99-4 RAP for troubleshooting procedure. Perform the Duplex Clutch test. The Inverter Reverse Clutch (CCW) energizes. Y↓N→Check the circuit of the Inverter Reverse Clutch. Refer to OF 99-4 RAP for troubleshooting procedure. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If the 10-125 occurs when duplexing, there may be excessive clearance between the Tray Nip Solenoid arm and shaft. Refer to TAG F-001.