Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-350 — Xerox Phaser 7760

Code: 010-350

Description: Fuser Sub Lamp Heat Fail The Rear Thermistor has detected an overheat condition.
Remedy: 1 1. Turn the printer power Off. Remove the Fuser Assembly and allow it to cool down. 2. Measure the resistance between the Fuser connector P600-7 -and P600-9. 3. Does the resistance measure between 30 K and 190 K Ohms? Go to step 2. Replace the Fuser (PL 7.1). 2 1. Reinstall the Fuser Assembly. 2. Enter Service Diagnostics Menu (refer to Control Panel Diagnostics). Perform the Fuser Temperature test. 3. Is the temperature indicated approximately 165°C? Go to step 4. Go to step 3. 3 1. Turn the printer power Off. 2. Measure the resistance between J641-4 J641-5 on the Engine Control Board. 3. Does the resistance measure between 30 K and 190 K Ohms? Replace the Engine Control Board (MCU PWB). Repair or replace the wiring harness. 4 1. Turn the printer power On. 2. Is there ~+3.4 VDC between J590-3? Check the AC wiring harness to the Fuser. If the check is OK, replace the AC Drive Assembly. Replace the Engine Control Board (MCU PWB).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie