Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-352 — Xerox Phaser 7760

Code: 010-352

Description: Main Heater Warm Up The temperature did not reach the Ready temperature.
Remedy: 1 Turn off the power, remove the Fuser, and allow it to cool down. Measure the resistance between the Fuser connector P600-1 and P600-12 on the Fuser Assembly (pin numbers are marked on tapered edge of P600 housing. Is less than 20 ohms measured? Go to step 2. Replace the Fuser (PL 7.1). 2 Measure the resistance between the Fuser connector pins P600-4 -and P600-5. Is the resistance between 30 and 190 ohms? Go to step 3. Replace the Fuser (PL 7.1). 3 Reinstall the Fuser and switch on the power. Measure the voltage between P/J48 and P/ J46 on the AC Drive PWB (PL 9.2). Is it AC Line Voltage? Go to step 4. Go to step 5. 4 and . Check the wires and connectors for continuity and that they are not grounding to the frame. Is the check OK? Replace the Fuser (PL 7.1). Repair the wiring harness. 5 Measure the voltage at P/J590-5 on the AC Drive PWB (PL 9.2). Is it less than 1 VDC? Go to step 7. Go to step 6. 6 Check the wires and connectors for continuity and that they are not grounding to frame. Is the check OK? Replace the Engine Control Board (MCU PWB). Repair the wiring harness. 7 While the Fuser is warming up, is +5VDC is measured at P/J590-2 on the AC Drive PWB (PL 9.2)? Replace the AC Power Chassis Assembly (PL 9.2). Go to step 8. 8 Check the wires and connectors for continuity and that they are not grounding to frame. Is the check OK? Replace the Engine Control Board (MCU PWB). Repair the wiring harness.

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie