Description: Booklet In Sensor On Jam The Booklet In Sensor did not turn On within the specified time after Punch Out Sensor ON.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Booklet In Sensor (PL 21.21). The display changes. Y↓N→Check the circuit of the Booklet In Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Booklet Gate Solenoid test. The Booklet Gate Solenoid (PL 21.21) actuates. Y↓N→Check the circuit of the Booklet Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Perform the Finisher Transport Motor test. The Finisher Transport Motor PL 21.10) energizes. Y↓N→Check the circuit of the Finisher Transport Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or alignment If the above checks are OK, then replace the Booklet In Sensor (PL 21.25). If the problem persists, replace the Finisher PWB (PL 21.12).