Description: Booklet Folder Roll Exit Sensor On Jam Booklet Folder Roll Exit Sensor is not turned Off within a specified time.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Booklet Folder Roll Exit Sensor (PL 21.21). The display changes. Y↓N→Check the circuit of the Booklet Folder Roll Exit Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Finisher Motors test (PL 21.22). The motor energizes. Y↓N→Check the circuit of the Booklet Paper Path Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Perform the Finisher Motors test (PL 21.22). The motor energizes. Y↓N→Check the circuit of the Booklet Folder Roll Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Booklet Paper Path Motor and its associated gears and belts for damage, contamination or alignment • Check the Booklet Folder Roll Motor and its associated gears and belts for damage, contamination or alignment If the above checks are OK, then replace the Booklet Folder Roll Exit Sensor (PL 21.21). If the problem persists, replace the Finisher PWB (PL 21.12).