Description: H-Transport Tray Exit Sensor On Jam H-Transport Tray Exit Sensor is not turned On within a specified time.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Open the H-Transport Cover and actuate the H-Transport Tray Exit Sensor (PL 21.25). The display changes. Y↓N→Check the circuit of the H-Transport Tray Exit Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Finisher Motors test. The H-Transport Drive Motor (PL 21.26) energizes. Y↓N→Check the circuit of the H-Transport Drive Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Close the H-Transport Cover. Perform the Gate Solenoid test. The Gate Solenoid (PL 21.25) actuates. Y↓N→Check the circuit of the Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the H-Transport Motor and its associated gears and belts for damage, contamination or misalignment If the above checks are OK, then replace the H-Transport Exit Sensor (PL 21.25). If the problem persists, replace the Finisher PWB (PL 21.12).