Description: Xport Entrance Sensor On Jam Transport Entrance Sensor is not turned On within a specified time.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Transport Entrance Sensor (PL 21.10). The display changes. Y↓N→Check the circuit of the Transport Entrance Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Finisher Transport Motor test. The Finisher Transport Motor (PL 21.10) energizes. Y↓N→Check the circuit of the Finisher Transport Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or alignment If the above checks are OK, then replace the Transport Entrance Sensor (PL 21.10). If the problem persists, replace the Finisher PWB (PL 21.12).