Description: Buffer Path Sensor On Jam Buffer Path Sensor is not turned On within a specified time.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Buffer Path Sensor (PL 21.10). The display changes. Y↓N→Check the circuit of the Buffer Path Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Finisher Transport Motor test. The Finisher Transport Motor (PL 21.10) energizes. Y↓N→Check the circuit of the Finisher Transport Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Perform the Buffer Gate Solenoid test. The Gate Solenoid (PL 21.10) actuates. Y↓N→Check the circuit of the Buffer Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Buffer Rolls for obstructions • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or misalignment If the above checks are OK, then replace the Buffer Path Sensor (PL 21.10). If the problem persists, replace the Finisher PWB (PL 21.12).