Description: Compile Exit Sensor On Jam Not in the Punch mode: The Compile Exit Sensor did not turn On within the specified time after Punch Out Sensor On. In Punch mode: The Compile Exit Sensor did not turn On within the specified time after the punching operation had begun.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Compile Exit Sensor (PL 21.9). The display changes. Y↓N→Check the circuit of the Compile Exit Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Buffer Gate Solenoid test. The Buffer Gate Solenoid (PL 21.10) actuates. Y↓N→Check the circuit of the Buffer Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Perform the Transport Gate Solenoid test. The Transport Gate Solenoid (PL 21.10) actuates. Y↓N→Check the circuit of the Transport Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Perform the Exit Motor test. The Exit Motor (PL 21.8) energizes. Y↓N→Check the circuit of the Exit Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Exit Motor and its associated gears and belts for damage, contamination or tension If the above checks are OK, then replace the Compile Exit Sensor (PL 21.9). If the problem persists, replace the Finisher PWB (PL 21.12).