Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-161 — Xerox Phaser 7760

Code: 012-161

Description: Set Eject Jam The Compile Exit Sensor did not turn Off within the specified time after the Eject operation has begun.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Compile Exit Sensor (PL 21.9). The display changes. Y↓N→Check the circuit of the Compile Exit Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Paper Path/No Pick test, Exit Motor. The Exit Motor (PL 21.8) energizes. Y↓N→Check the circuit of the Exit Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Perform the Finisher Solenoids test. The Transport Gate Solenoid (PL 21.10) actuates. Y↓N→Check the circuit of the Transport Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Exit Motor and its associated gears and belts for damage, contamination or tension If the above checks are OK, then replace the Compile Exit Sensor (PL 21.9). If the problem persists, replace the Finisher PWB (PL 21.12).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie