Description: Top Tray Exit Sensor On Jam Not in the Punch mode: The Top Tray Exit Sensor did not turn On within the specified time after Punch Out Sensor On. In Punch mode: The Top Tray Exit Sensor did not turn on within the specified time after the punching operation had begun.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Top Tray Exit Sensor (PL 21.11) The display changes. Y↓N→Check the circuit of the Top Tray Exit Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Finisher Exit Motor test. The Exit Motor (PL 21.11) energizes. Y↓N→Check the circuit of the Exit Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Perform the Finisher Solenoids test. The Transport Gate Solenoid (PL 21.10) actuates. Y↓N→Check the circuit of the Transport Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Perform the Finisher Transport Motors test. The Finisher Transport Motor (PL 21.10) energizes. Y↓N→Check the circuit of the Finisher Transport Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Exit Motor and its associated gears and belts for damage, contamination or misalignment • Exit Drive Shaft for wear and a revolution failure • The Exit Pinch Rolls for wear and/or damage If the above checks are OK, then replace the Top Tray Exit Sensor (PL 21.11). If the problem persists, replace the Finisher PWB (PL 21.12).