Description: Top Tray Exit Sensor Off Jam The Top Tray Exit Sensor Off was not detected at the rear edge of paper within the specified time after Punch Out Sensor detected at the leading edge of the same paper. The Top Tray Exit Sensor Off was not detected at the rear edge of paper within the specified time after the punching operation had begun.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Top Tray Exit Sensor (PL 21.11). The display changes. Y↓N→Check the circuit of the Top Tray Exit Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Finisher Exit Motor test. The Exit Motor (PL 21.11) energizes. Y↓N→Check the circuit of the Exit Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Perform the Transport Gate Solenoid test. The Transport Gate Solenoid (PL 21.10) actuates. Y↓N→Check the circuit of the Transport Gate Solenoid. Refer to OF 99-8 RAP for troubleshooting procedure. Perform the Finisher Transport Motor test. The Finisher Transport Motor (PL 21.10) energizes. Y↓N→Check the circuit of the Finisher Transport Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Exit Motor and its associated gears and belts for damage, contamination or misalignment • Exit Drive Shaft for wear and a revolution failure • The Exit Pinch Rolls for wear and/or damage If the above checks are OK, then replace the top Tray Exit Sensor (PL 21.11). If the problem persists, replace the Finisher PWB (PL 21.12).