Description: Stacker Upper Limit Fail When Stack Height Sensor 2 On was detected after the Stacker Tray had started lifting up.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Elevator Motor alternately. The Elevator Motor (PL 21.4) runs. Y↓N→Check continuity between the Elevator Motor and Finisher Main PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Elevator Motor (PL 21.4). If the problem continues, replace the Finisher PWB (PL 21.12). Enter the Service Diagnostics menu. Block/unblock the Stacker No Paper Sensor (PL 21.4). The display changes. Y↓N→Check continuity between the Stacker No Paper Sensor and Finisher PWB. The continuity check is OK, Y↓N→Repair the open circuit or short circuit. Replace the Stacker No Paper Sensor (PL 21.4). If the problem continues, replace the Finisher PWB Enter the Service Diagnostics menu. Block/unblock the Upper Limit Sensor (PL 21.4). The display changes. Y↓N→Check continuity between the Upper Limit Sensor and Finisher PWB. The continuity check is OK, Y↓N→Repair the open circuit or short circuit. Replace the Upper Limit Sensor (PL 21.4). If the problem continues, replace the Finisher PWB. If the problem continues, replace the Finisher PWB (PL 21.12).