Code: 012-233
Description: Puncher Move Home Sensor On Fail Puncher Move Home Sensor is not turned On after the lapse of 400(300*500**)msec from operation start.Puncher Move Home Sensor is not turned on after the stop following Puncher Move Home Sensor On.
Remedy: Check the following components: • Actuator for deformation • Puncher Move Home Sensor for improper installation • Puncher Move Home Sensor connectors for connection failure • Puncher Move Motor connectors for connection failure
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Puncher Move Motor test. The Puncher Move Motor (PL 21.5) energizes. Y↓N→Check continuity between the Puncher Move Motor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Motor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Block/unblock the Puncher Move Home Sensor (PL 21.5). The display changes. Y↓N→Check continuity between the Puncher Move Home Sensor and Finisher Main PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Home Sensor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Check the following: • Puncher Move Motor rack and gear for binding, wear, or damage If the above check is OK, replace the Finisher PWB (PL 21.12).
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Puncher Move Motor test. The Puncher Move Motor (PL 21.5) energizes. Y↓N→Check continuity between the Puncher Move Motor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Motor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Block/unblock the Puncher Move Home Sensor (PL 21.5). The display changes. Y↓N→Check continuity between the Puncher Move Home Sensor and Finisher Main PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Home Sensor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Check the following: • Puncher Move Motor rack and gear for binding, wear, or damage If the above check is OK, replace the Finisher PWB (PL 21.12).