Code: 012-234
Description: Puncher Move Home Sensor Off Fail Puncher Move Home Sensor is not turned Off after the lapse of 1000 (100*) msec. from operation start. Puncher Move Home Sensor is not turned Off after the stop following Puncher Move Home Sensor Off.
Remedy: • Check the Actuator for deformation. • Check the Puncher Move Home Sensor for improper installation. • Check the Puncher Move Home Sensor connectors for connection failure. • Check the Puncher Move Motor connectors for connection failure.
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Puncher Move Motor test. The Puncher Move Motor (PL 21.5) runs. Y↓N→Check continuity between the Puncher Move Motor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Motor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Block/unblock the Puncher Move Home Sensor (PL 21.5). The display changes. Y↓N→Check continuity between the Puncher Move Home Sensor and Finisher Main PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Home Sensor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Check the following: • The Puncher Move Motor Belt for improper tension • The Puncher Move Motor Belt for disengagement If the above checks are OK, replace the Finisher PWB (PL 21.12).
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Puncher Move Motor test. The Puncher Move Motor (PL 21.5) runs. Y↓N→Check continuity between the Puncher Move Motor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Motor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Block/unblock the Puncher Move Home Sensor (PL 21.5). The display changes. Y↓N→Check continuity between the Puncher Move Home Sensor and Finisher Main PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Puncher Move Home Sensor (PL 21.5). If the problem continues, replace the Finisher PWB (PL 21.12). Check the following: • The Puncher Move Motor Belt for improper tension • The Puncher Move Motor Belt for disengagement If the above checks are OK, replace the Finisher PWB (PL 21.12).