Description: Rear Tamper Home Sensor On Fail The Rear Tamper Home Sensor did not turn On within the specified time after the Tamper Motor had started running.
Remedy: • Rear Tamper Actuator for deformation • Rear Tamper Home Sensor for proper installation • Rear Tamper Home Sensor connectors • Rear Tamper Motor for proper operation • Rear Tamper Motor connectors Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Rear Tamper Motor alternately. The Rear Tamper Motor (PL 21.8) runs. Y↓N→Check circuit of the Rear Tamper Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Enter Service Diagnostics Menu. Actuate the Rear Tamper Home Sensor (PL 21.8) with a piece of paper. The display changes. Y↓N→Check circuit of the Rear Tamper Home Sensor. Refer to Transmissive Sensor Procedure () for troubleshooting procedure. If the problem continues, replace the Finisher PWB (PL 21.12).