Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-284 — Xerox Phaser 7760

Code: 012-284

Description: Set Clamp Home Sensor Off Fail Set Clamp Home Sensor is not turned Off within a specified time.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Eject Clamp Home Sensor (PL 21.8). The display changes. Y↓N→Check the circuit of the Eject Clamp Home Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Eject Motor test. The Eject Motor (PL 21.8) moves up. Y↓N→The Eject Motor energized. Y↓N→Check the circuit of the Eject Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Eject Motor and its associated gears, pulleys and belts for damage, contamination and misalignment (PL 21.8). Perform the Set Clamp Clutch test. The Eject Roll Shaft (PL 21.8) rotates. Y↓N→The Set Clamp Clutch energized. Y↓N→Check the circuit of the Set Clamp Clutch. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Set Clamp Clutch and its associated gears, pulleys and belts for damage, contamination and misalignment (PL 21.8). Check the following: • Ensure that the Eject Clamp Home Sensor connectors are securely connected and that the wires are not damaged • Ensure that the Eject Motor connectors are securely connected and that the wires are not damaged If the above checks are OK, replace the Eject Clamp Home Sensor (PL 21.7). If the problem persists, replace the Finisher PWB (PL 21.12).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie