Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-287 — Xerox Phaser 7760

Code: 012-287

Description: Decurler Home Sensor Off Fail Decurler Move Home Sensor is not turned Off after the lapse of 1000msec from the detection of Decurler Home Sensor On.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Decurler Home Sensor (PL 21.26). The display changes. Y↓N→Check the circuit of the Decurler Home Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Decurler Cam Clutch test (PL 21.26). The Decurler Roll Shaft rotates. Y↓N→The Decurler Cam Clutch energized. Y↓N→Check the circuit of the Decurler Cam Clutch. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Decurler Cam Clutch and its associated gears, pulleys and belts for damage, contamination and misalignment (PL 21.26). Check the following: • Ensure that the Decurler Cam Home Sensor connectors are securely connected and that the wires are not damaged • Ensure that the Decurler Cam Clutch connectors are securely connected and that the wires are not damaged • H-Transport Motor Drive belt for wear, damage, or loose • H-Transport Motor connections are securely connected and that the wires are not damaged If the above checks are OK, replace the Decurler Home Sensor (PL 21.26). If the problem continues, replace the H-Transport PWB (PL 21.12). If the problem persists, replace the Finisher PWB (PL 21.12).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie