Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-296 — Xerox Phaser 7760

Code: 012-296

Description: Stapler Move Position Sensor Off Fail The Staple Move Sensor does not turn Off within 5 seconds after the move to the Staple position has started. Or, the Staple Move Sensor turned Off after the Staple position has been fixed. Or, the Staple Move Sensor does not turn Off within 5 seconds after it has turned On when the paper passed through the 1st position of the dual staple, moving to the rear staple position.
Remedy: 1 1. Manually move the Staple Head. 2. Does the Head move smoothly from front to rear? To to step 2. Diagnose and repair the mechanical defect. 2 1. Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. 2. Perform the Staple Move Sensor test. 3. Does the value change from L to H when the Sensor is blocked? Go to step 3. Refer to Transmissive Sensor Procedure () to diagnose and repair the Sensor. 3 1. Measure the voltage at the Finisher Board connector P852-1. 2. Does the voltage measure +5 VDC? The Home Sensor or the wiring is bad. Replace the Stapler Assembly. Go to step 4. 4 Is +24 VDC present at P847 pins 1, 2, 5, and 6? Replace the following order: 1. Stapler Move Motor 2. Finisher PWB Go to step 5. 5 Is +24 VDC present at P847-4? Replace the Finisher PWB. Troubleshoot the +24 VDC Interlock circuit using 24 VDC Low-Voltage Power Supplies troubleshooting procedure ().

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie