Code: 012-302
Description: Finisher Front Door Interlock Open (A/P Finisher) Finisher Front Door Switch Open was detected.
Remedy: Check the following components: • Finisher Front Door Switch for proper installation. • Finisher Front Door Switch connectors for connection failure. • Actuator part for deformation. • Ensure that the Eject Cover is in the closed/down position.
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Front Door Interlock Switch (PL 21.3). Open and close the Front Door. The display changes. Y↓N→Disconnect P/J8314 on the Finisher PWB. +5 VDC is measured between the Finisher PWB P8314-2 and P8314-3. Y↓N→Replace the Finisher PWB (PL 21.12). There is less than 5 ohms between P?J8314-3 and the finisher frame. Y↓N→Replace the Finisher PWB (PL 21.12). Check the wires between the Finisher PWB, the Eject Cover Switch and the Finisher Front Door Switch for an open circuit or poor contact. If the wires are good, replace the Front Door Interlock Switch (PL 21.3). Check the following: • Alignment between the Front Door and the Front Door Interlock Switch • Front Door and Front Cover for proper installation • Actuator for damage or bent • Magnet for proper mounting If the above checks are OK, replace the Finisher PWB (PL 21.12).
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Front Door Interlock Switch (PL 21.3). Open and close the Front Door. The display changes. Y↓N→Disconnect P/J8314 on the Finisher PWB. +5 VDC is measured between the Finisher PWB P8314-2 and P8314-3. Y↓N→Replace the Finisher PWB (PL 21.12). There is less than 5 ohms between P?J8314-3 and the finisher frame. Y↓N→Replace the Finisher PWB (PL 21.12). Check the wires between the Finisher PWB, the Eject Cover Switch and the Finisher Front Door Switch for an open circuit or poor contact. If the wires are good, replace the Front Door Interlock Switch (PL 21.3). Check the following: • Alignment between the Front Door and the Front Door Interlock Switch • Front Door and Front Cover for proper installation • Actuator for damage or bent • Magnet for proper mounting If the above checks are OK, replace the Finisher PWB (PL 21.12).