Description: Paper at Gate Sensor (Compiler Path Job) Control logic reports paper at the Gate Sensor.
Remedy: • Check for obstructions in the paper path. • Check the Finisher Drive Motor Gears and Drive rolls for wear or damage. Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Gate Sensor (PL 21.11). The display changes. Y↓N→Check the circuit of the Gate Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Finisher is docked properly • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or misalignment If the above checks are OK, then replace the Gate Sensor (PL 21.11). If the problem persists, replace the Finisher PWB (PL 21.12).