Code: 012-935
Description: Paper at Xport Entrance Sensor Control logic reports paper at the Xport Entrance Sensor.
Remedy: • Check for obstructions in the paper path • Check that the Finisher is dock correctly to ensure proper Transport Gate operation
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Transport Entrance Sensor (PL 21.10). The display changes. Y↓N→Check the circuit of the Transport Entrance Sensor.. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or alignment If the above checks are OK, then replace the Transport Entrance Sensor (PL 21.25). If the problem persists, replace the Finisher PWB (PL 21.12).
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Actuate the Transport Entrance Sensor (PL 21.10). The display changes. Y↓N→Check the circuit of the Transport Entrance Sensor.. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or alignment If the above checks are OK, then replace the Transport Entrance Sensor (PL 21.25). If the problem persists, replace the Finisher PWB (PL 21.12).