Code: 012-961
Description: Mix Stack was Detected Mix Stack Sensor On was detected during Mix Job.
Remedy: • Check the Elevator Motor for operation failure. • Check the Elevator Motor connectors for connection failure. CAUTION Caution must be used when activating Elevator Motor test. When activating this test in the Down position, there is no limit sensor for downward Stacker travels. Downward steps increment (or decrement) in single steps, not 5. When continuing in the Down direction, DO NOT continue after an initial thump sound is heard. Further downward movements may cause damage to the Stacker Unit/Finisher.
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Verify that NVRAM location Printer/Finisher 2274 is set to 0. NVM Printer/Finisher 2274 is set to 0. Y↓N→Write a value of 0 in Printer/Finisher 2274. Perform the Elevator Motor test (PL 21.4). The Elevator Motor energizes. Y↓N→Check continuity between the Elevator Motor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Elevator Motor (PL 21.4). If the problem continues, replace the FInisher PWB (PL 21.12). If the problem continues, replace the Finisher PWB (PL 21.12).
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Verify that NVRAM location Printer/Finisher 2274 is set to 0. NVM Printer/Finisher 2274 is set to 0. Y↓N→Write a value of 0 in Printer/Finisher 2274. Perform the Elevator Motor test (PL 21.4). The Elevator Motor energizes. Y↓N→Check continuity between the Elevator Motor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Elevator Motor (PL 21.4). If the problem continues, replace the FInisher PWB (PL 21.12). If the problem continues, replace the Finisher PWB (PL 21.12).