Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-930 — Xerox Phaser 7760

Code: 024-930

Description: Finisher Stacker Tray Full Stack (Large Size Full) Stacker No Paper Sensor On was detected during the Stacker Tray height adjusting operation.
Remedy: • Check the Stacker No Paper Sensor for improper installation. • Check the Stacker No Paper Sensor connectors for connection failure. • Check the Elevator Motor for operation failure. • Check the Elevator Motor connectors for connection failure. CAUTION Caution must be used when activating the Elevator Motor test. When activating this test in the Down position, there is no limit sensor for downward Stacker travels. Downward steps increment (or decrement) in single steps, not 5. When continuing in the Down direction, DO NOT continue after an initial thump sound is heard. Further downward movements may cause damage to the Stacker Unit/Finisher.
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Elevator Motor test alternately. The Elevator Motor (PL 21.4) energizes. Y↓N→Check continuity between the Elevator Motor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Elevator Motor (PL 21.4). If the problem continues, replace the Finisher PWB (PL 21.12). Block/unblock the Stacker No Paper Sensor (PL 21.4). The display changes. Y↓N→Check continuity between the Stacker No Paper Sensor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Stacker No Paper Sensor (PL 21.4). If the problem continues, replace the Finisher PWB (PL 21.12). Block/unblock the Stacker Encoder Sensor (PL 21.4). The display changes. Y↓N→Check continuity between the Stacker Encoder Sensor and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Stacker Encoder Sensor (PL 21.4). If the problem continues, replace the Finisher PWB (PL 21.12). If the problem continues, replace the Finisher PWB (PL 21.12).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie