Code: 024-976
Description: Finisher Staple Status NG The Staple Home Sensor has not switched Off to On within the specified time after the Staple Motor started rotating forward. The Staple Head Home Sensor turned On within xxx msec. after the Staple Motor reversed.
Remedy: • Check the Actuator for deformation. • Check the Staple Home Sensor for improper installation. • Check the Staple Home Sensor connectors for connection failure. • Check the Staple Guide for a foreign substance and deformation. • Check the Staple Motor for operating failure. • Check the Staple Motor connectors for connection failure.
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Staple Motor test alternately. The Staple Motor (PL 21.6) energizes. Y↓N→Check continuity between the Stapler Head and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Stapler Head (PL 21.6). If the problem continues, replace the Finisher PWB (PL 21.12). Actuate the Staple Home Sensor (PL 21.6). Perform the Staple Motor test alternately. The display changes. Y↓N→Check continuity between the Stapler Head and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Stapler Head (PL 21.6). If the problem continues, replace the Finisher PWB (PL 21.12). If the problem continues, replace the Finisher PWB (PL 21.12).
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Staple Motor test alternately. The Staple Motor (PL 21.6) energizes. Y↓N→Check continuity between the Stapler Head and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Stapler Head (PL 21.6). If the problem continues, replace the Finisher PWB (PL 21.12). Actuate the Staple Home Sensor (PL 21.6). Perform the Staple Motor test alternately. The display changes. Y↓N→Check continuity between the Stapler Head and Finisher PWB. The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Stapler Head (PL 21.6). If the problem continues, replace the Finisher PWB (PL 21.12). If the problem continues, replace the Finisher PWB (PL 21.12).