Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 310.329 — Xerox Phaser 7800

Code: 310.329

Description: Fuser Cut Fail After the fuser is replaced with new one, the fuse (fuse1) did not change to Open state in 1 sec.
Remedy: • Turn the power Off and check whether the Fuser Assembly is installed properly. Power back on and if the error has not cleared, follow the procedure.
Remove the Fuser Assembly and check the resistance between pins A1 and A2 on the Fuser Assembly. Is the readying ~0 ohms? Y↓ N→Check the wiring between DJ600-A10 and J431-2 on the MCU PWB. Is the resistance ~0 ohms? Y↓ N→Repair the wiring. Is the voltage between DJ600 A11 (+) and the GND (-) +3.3VDC? Y↓ N→Is the voltage between J431-1 (+) and the GND (-) +3.3VDC? Y↓ N→Repair the wiring Replace the MCU PWB. Replace the MCU PWB. Replace the MCU PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie