Description: H-Transport Entrance Sensor On Jam A. After the Fuser Exit Sensor turned on, the H-Transport Entrance Sensor did not turn on within the specified time.
Remedy: Check the H-Transport Drive Rolls (PL 23.4) and Pinch Rolls (PL 23.3) for wear or contamination. Check for obstructions or damage in the paper path. The Paper Path is OK. Y↓ N→Clean or replace as required. Execute dc330 Component Control [012-190], H-Transport Entrance Sensor. Actuate the HTransport Entrance Sensor (PL 23.4). The display changes. Y↓ N→Check the wire between P/J8861 pin 2 and P8987 pin 6 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between P8987, pins 4 and 5 on the Finisher PWB (Horizontal Paper Transportation). The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between P8987, pin 6 on the Finisher PWB and GND (Horizontal Paper Transportation). Actuate the H-Transport Entrance Sensor. The voltage changes. Y↓ N→Replace the H-Transport Entrance Sensor (PL 23.4). Replace the Finisher PWB. Power Off the printer. Open the H-Transport Top Cover. Cheat the H-Transport Interlock Sensor. Power On the printer. The H-Transport Belt rotates. Y↓ N→Check the wires between P/J8862 on the H-Transport Motor and P8987 on the Finisher PWB for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓ N→Repair/reconnect as required. Measure the resistance of the H-Transport Motor between each pin P/J8862-1/2/5/6 (Horizontal Paper Transportation). The resistance is approx. 20 Ohm. Y↓ N→Replace the H-Transport Motor. Replace the Finisher PWB. If the problem persists, replace the H-Transport Motor. Check the H-Transport Entrance Sensor and H-Transport Motor circuits for an intermittent condition. If the problem continues, replace the Finisher PWB.