Code: 312.113
Description: Booklet In Sensor On Jam. The Booklet In Sensor did not turn on within the specified time after Punch Out Sensor On.
Remedy: • Check for obstructions in the paper path. • Check that the Finisher is dock correctly to ensure proper Transport Gate operation. • Check the Booklet In Sensor (PL 24.57 Item 5) for obstructions. • Check for transportation failure of non-standard paper. • Check the Booklet In Roll for wear or damage.
Enter dc330 Component Control [013-135], Booklet In Sensor (PL 24.57 Item 5). Select Start. Actuate the Booklet In Sensor. The display changes. Y↓ N→Go to Booklet Transportation. Check the circuit of the Booklet In Sensor. Refer to the Transmissive Sensor for troubleshooting procedure. Select [013-068] and/or [013-069], Booklet Gate Solenoid (PL 24.42 Item 9). Select Start. The Booklet Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Booklet/ Punch Transport. Check the circuit of the Booklet Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select [012-001], Finisher Transport Motor (PL 24.41 Item 26). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher H-Transport Drives. Check the circuit of the Finisher Transport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment. • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or alignment. If the above checks are OK, then replace the Booklet In Sensor (PL 24.57 Item 5). If the problem persists, replace the Finisher Main PWB.
Enter dc330 Component Control [013-135], Booklet In Sensor (PL 24.57 Item 5). Select Start. Actuate the Booklet In Sensor. The display changes. Y↓ N→Go to Booklet Transportation. Check the circuit of the Booklet In Sensor. Refer to the Transmissive Sensor for troubleshooting procedure. Select [013-068] and/or [013-069], Booklet Gate Solenoid (PL 24.42 Item 9). Select Start. The Booklet Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Booklet/ Punch Transport. Check the circuit of the Booklet Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select [012-001], Finisher Transport Motor (PL 24.41 Item 26). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher H-Transport Drives. Check the circuit of the Finisher Transport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment. • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or alignment. If the above checks are OK, then replace the Booklet In Sensor (PL 24.57 Item 5). If the problem persists, replace the Finisher Main PWB.