Code: 312.114
Description: Booklet In Sensor Off Jam. The Booklet In Sensor did not turn off within the specified time.
Remedy: • Check for obstructions in the paper path. • Check that the Finisher is dock correctly to ensure proper Transport Gate operation. • Check the Booklet In Sensor (PL 24.57 Item 5) for obstructions. • Check for transportation failure of non-standard paper. • Check the Booklet In Roll for wear or damage.
Enter dc330 Component Control [013-135], Booklet In Sensor (PL 24.57 Item 5). Select Start. Actuate the Booklet In Sensor. The display changes. Y↓ N→Go to Booklet Transportation. Check the circuit of the Booklet In Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [013-068] and/or [013-069], Booklet Gate Solenoid (PL 24.42 Item 9). Select Start. The Booklet Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Booklet/ Punch Transport. Check the circuit of the Booklet Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select [013-064], Booklet Paper Path Motor (PL 24.58 Item 4). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Booklet Drive. Check the circuit of the Booklet Paper Path Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment. • Check the Booklet Paper Path Motor and its associated gears and belts for damage, contamination or alignment. If the above checks are OK, then replace the Booklet In Sensor (PL 24.57 Item 5). If the problem persists, replace the Finisher Main PWB.
Enter dc330 Component Control [013-135], Booklet In Sensor (PL 24.57 Item 5). Select Start. Actuate the Booklet In Sensor. The display changes. Y↓ N→Go to Booklet Transportation. Check the circuit of the Booklet In Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [013-068] and/or [013-069], Booklet Gate Solenoid (PL 24.42 Item 9). Select Start. The Booklet Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Booklet/ Punch Transport. Check the circuit of the Booklet Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select [013-064], Booklet Paper Path Motor (PL 24.58 Item 4). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Booklet Drive. Check the circuit of the Booklet Paper Path Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment. • Check the Booklet Paper Path Motor and its associated gears and belts for damage, contamination or alignment. If the above checks are OK, then replace the Booklet In Sensor (PL 24.57 Item 5). If the problem persists, replace the Finisher Main PWB.