Code: 312.115
Description: Booklet Folder Roll Exit Sensor On Jam. Booklet Folder Roll Exit Sensor is not turned off within a specified time.
Remedy: • Check for obstructions in the paper path • Check that the Finisher is dock correctly to ensure proper Transport Gate operation. • Check the Booklet Folder Roll Exit Sensor (PL 24.57 Item 21) for obstructions. • Check for transportation failure of non-standard paper. • Check the Booklet Folding Roll for wear or damage. • Check the Booklet Eject Roll Drive rolls for wear or damage.
Enter dc330 Component Control [013-103], Booklet Folder Roll Exit Sensor (PL 24.57 Item 21). Select Start. Actuate the Booklet Folder Roll Exit Sensor. The display changes. Y↓ N→Go to Booklet Transportation. Check the circuit of the Booklet Folder Roll Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [013-064], Booklet Paper Path Motor (PL 24.58 Item 4). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Booklet Drive. Check the circuit of the Booklet Paper Path Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Select [013-008], Booklet Folder Roll Motor (PL 24.58 Item 2). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Booklet Drive. Check the circuit of the Booklet Folder Roll Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the Booklet Paper Path Motor and its associated gears and belts for damage, contamination or alignment. • Check the Booklet Folder Roll Motor and its associated gears and belts for damage, contamination or alignment. If the above checks are OK, then replace the Booklet Folder Roll Exit Sensor (PL 24.57 Item 21). If the problem persists, replace the Finisher Main PWB.
Enter dc330 Component Control [013-103], Booklet Folder Roll Exit Sensor (PL 24.57 Item 21). Select Start. Actuate the Booklet Folder Roll Exit Sensor. The display changes. Y↓ N→Go to Booklet Transportation. Check the circuit of the Booklet Folder Roll Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [013-064], Booklet Paper Path Motor (PL 24.58 Item 4). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Booklet Drive. Check the circuit of the Booklet Paper Path Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Select [013-008], Booklet Folder Roll Motor (PL 24.58 Item 2). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Booklet Drive. Check the circuit of the Booklet Folder Roll Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the Booklet Paper Path Motor and its associated gears and belts for damage, contamination or alignment. • Check the Booklet Folder Roll Motor and its associated gears and belts for damage, contamination or alignment. If the above checks are OK, then replace the Booklet Folder Roll Exit Sensor (PL 24.57 Item 21). If the problem persists, replace the Finisher Main PWB.