Code: 312.124
Description: H-Transport Top Tray Exit Sensor Off Jam. H-Transport Top Tray Exit Sensor is not turned off within a specified time.
Remedy: • Check for obstructions in the paper path. • Check that the Finisher is dock correctly to ensure proper Transport Gate operation. • Check the H-Transport Motor Belt for wear or damage. • Check the Guides on the H-Transport Cover for damage, wear or faulty installation.
Enter dc330 Component Control [012-191], H-Transport Exit Sensor (PL 24.6 Item 8). Select Start. Open the H-Transport Cover and actuate the H-Transport Exit Sensor. The display changes. Y↓ N→Go to Finisher Horizontal Transportation (2 of 2). Check the circuit of the HTransport Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select Stop. Select [012-090], H-Transport Motor (PL 24.6 Item 22). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher H-Transport Drives. Check the circuit of the HTransport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Close the H-Transport Cover. Select [012-086] or [012-087], H-Transport Gate Solenoid (PL 24.2). Select Start. The Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher H-Transport Drives. Check the circuit of the Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or misalignment. If the above checks are OK, then replace the H-Transport Exit Sensor (PL 24.6 Item 8). If the problem persists, replace the Finisher Main PWB.
Enter dc330 Component Control [012-191], H-Transport Exit Sensor (PL 24.6 Item 8). Select Start. Open the H-Transport Cover and actuate the H-Transport Exit Sensor. The display changes. Y↓ N→Go to Finisher Horizontal Transportation (2 of 2). Check the circuit of the HTransport Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select Stop. Select [012-090], H-Transport Motor (PL 24.6 Item 22). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher H-Transport Drives. Check the circuit of the HTransport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Close the H-Transport Cover. Select [012-086] or [012-087], H-Transport Gate Solenoid (PL 24.2). Select Start. The Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher H-Transport Drives. Check the circuit of the Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or misalignment. If the above checks are OK, then replace the H-Transport Exit Sensor (PL 24.6 Item 8). If the problem persists, replace the Finisher Main PWB.