Code: 312.125
Description: Gate Sensor On Jam. Gate Sensor is not turned on within a specified time.
Remedy: • Check for obstructions in the paper path. • Check the Finisher Drive Motor Gears and Drive rolls for wear or damage.
Enter dc330 Component Control [012-191], H-Transport Exit Sensor. Select Start. Open the H-Transport Cover and actuate the H-Transport Exit Sensor. The display changes. Y↓ N→Go to Finisher Horizontal Transportation (2 of 2). Check the circuit of the HTransport Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Enter dc330 Component Control [012-102], Gate Sensor (PL 24.43 Item 19). Select Start. Actuate the Gate Sensor. The display changes. Y↓ N→Go to Finisher Transport, Top Tray Gating. Check the circuit of the Gate Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [012-001], Finisher Transport Motor 1 Speed (PL 24.41). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher Transport, Top Tray Gating. Check the circuit of the Finisher Transport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the Finisher is docked properly. • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or misalignment. If the above checks are OK, then replace the Gate Sensor. If the problem persists, replace the Finisher Main PWB.
Enter dc330 Component Control [012-191], H-Transport Exit Sensor. Select Start. Open the H-Transport Cover and actuate the H-Transport Exit Sensor. The display changes. Y↓ N→Go to Finisher Horizontal Transportation (2 of 2). Check the circuit of the HTransport Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Enter dc330 Component Control [012-102], Gate Sensor (PL 24.43 Item 19). Select Start. Actuate the Gate Sensor. The display changes. Y↓ N→Go to Finisher Transport, Top Tray Gating. Check the circuit of the Gate Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [012-001], Finisher Transport Motor 1 Speed (PL 24.41). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher Transport, Top Tray Gating. Check the circuit of the Finisher Transport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the Finisher is docked properly. • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or misalignment. If the above checks are OK, then replace the Gate Sensor. If the problem persists, replace the Finisher Main PWB.