Description: Transport Entrance Sensor On Jam. Transport Entrance Sensor is not turned on within a specified time.
Remedy: • Check for obstructions in the paper path. • Check that the Finisher is dock correctly to ensure proper Transport Gate operation. Enter dc330 Component Control [012-100], Transport Entrance Sensor (PL 24.41 Item 19). Select Start. Actuate the Transport Entrance Sensor. The display changes. Y↓ N→Go to Finisher Transport, Top Tray Gating. Check the circuit of the Transport Entrance Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [012-001], Finisher Transport Motor 1 Speed (PL 24.41). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher Drives. Check the circuit of the Finisher Transport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or alignment. • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or alignment. If the above checks are OK, then replace the Transport Entrance Sensor (PL 24.41 Item 19). If the problem persists, replace the Finisher Main PWB.