Code: 312.142
Description: Buffer Path Sensor On Jam. Buffer Path Sensor is not turned on within a specified time.
Remedy: • Check for obstructions in the paper path. • Check the Finisher Transport Motor Belt, Gears and Drive Rolls for wear or damage.
Enter dc330 Component Control [012-101], Buffer Path Sensor (PL 24.41 Item 10). Select Start. Actuate the Buffer Path Sensor. The display changes. Y↓ N→Go to Finisher Buffer Transport. Check the circuit of the Buffer Path Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [012-001], Finisher Transport Motor 1 Speed (PL 24.41). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher Drives. Check the circuit of the Finisher Transport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Select [012-015] and/or [012-016], Buffer Gate Solenoid. Select Start. The Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Buffer Transport. Check the circuit of the Buffer Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the Buffer Rolls for obstructions. • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or misalignment. If the above checks are OK, then replace the Buffer Path Sensor (PL 24.41 Item 10). If the problem persists, replace the Finisher Main PWB.
Enter dc330 Component Control [012-101], Buffer Path Sensor (PL 24.41 Item 10). Select Start. Actuate the Buffer Path Sensor. The display changes. Y↓ N→Go to Finisher Buffer Transport. Check the circuit of the Buffer Path Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [012-001], Finisher Transport Motor 1 Speed (PL 24.41). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher Drives. Check the circuit of the Finisher Transport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Select [012-015] and/or [012-016], Buffer Gate Solenoid. Select Start. The Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Buffer Transport. Check the circuit of the Buffer Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the Buffer Rolls for obstructions. • Check the Finisher Transport Motor and its associated gears and belts for damage, contamination or misalignment. If the above checks are OK, then replace the Buffer Path Sensor (PL 24.41 Item 10). If the problem persists, replace the Finisher Main PWB.