Code: 312.151
Description: Compiler Exit Sensor Off Jam. The Compiler Exit Sensor did not turn Off within the specified time after Compiler Exit Sensor On.
Remedy: • Check the Buffer Reverse Roll for wear or damage. • Check the Compile Exit Roll for wear or damage. • Check for paper transportation failure due to a foreign substance/burr on the paper path. • Check for transportation failure of non-standard paper.
Enter dc330 Component Control [012-150], Compiler Exit Sensor (PL 24.36 Item 3). Select Start. Actuate the Compiler Exit Sensor. The display changes. Y↓ N→Go to Finisher Compiling Check the circuit of the Compiler Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select Stop. Select [012-011] or [012-012], Transport Gate Solenoid (PL 24.41 Item 37), and Select Start. The Transport Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Transport, Top Tray Gating. Check the circuit of the Transport Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select Stop. Select [012-015] or [012-016], Buffer Gate Solenoid (PL 24.41 Item 39), and Select Start. The Buffer Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Buffer Transport. Check the circuit of the Buffer Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select [012-007], Exit Motor (PL 24.43 Item 7). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher Drives. Check the circuit of the Exit Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Exit Motor and its associated gears and belts for damage, contamination or tension If the above checks are OK, then replace the Compiler Exit Sensor. If the problem persists, replace the Finisher Main PWB.
Enter dc330 Component Control [012-150], Compiler Exit Sensor (PL 24.36 Item 3). Select Start. Actuate the Compiler Exit Sensor. The display changes. Y↓ N→Go to Finisher Compiling Check the circuit of the Compiler Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select Stop. Select [012-011] or [012-012], Transport Gate Solenoid (PL 24.41 Item 37), and Select Start. The Transport Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Transport, Top Tray Gating. Check the circuit of the Transport Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select Stop. Select [012-015] or [012-016], Buffer Gate Solenoid (PL 24.41 Item 39), and Select Start. The Buffer Gate Solenoid actuates. Y↓ N→Select Stop. Go to Finisher Buffer Transport. Check the circuit of the Buffer Gate Solenoid. Refer to the Set Gate Solenoid Open RAP for troubleshooting procedure. Select [012-007], Exit Motor (PL 24.43 Item 7). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher Drives. Check the circuit of the Exit Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged • Check the Exit Motor and its associated gears and belts for damage, contamination or tension If the above checks are OK, then replace the Compiler Exit Sensor. If the problem persists, replace the Finisher Main PWB.