Description: Compiler Exit Sensor On Jam. After the H-Transport Exit Sensor turned On, the Compiler Exit Sensor did not turn On within the specified time.
Remedy: Execute dc330 Component Control [012-150], Compiler Exit Sensor. Actuate the Compiler Exit Sensor (PL 23.14). The display changes. Y↓ N→Check the wire between J8869 pin 2 and P/J8988 pin 5 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between P/J8988, pins 6 and 4 on the Finisher PWB (Finisher Paper Transportation). The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between P/J8988, pin 5 on the Finisher PWB and GND (Finisher Paper Transportation). Actuate the Compiler Exit Sensor. The voltage changes. Y↓ N→Replace the Compiler Exit Sensor (PL 23.14). Replace the Finisher PWB. Execute dc330 Component Control [012-038], Transport Motor. The Transport Motor rotates. Y↓ N→Check the wires between P/J8878 on the Transport Motor and P/J8893 on the Finisher PWB for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓ N→Repair/reconnect as required. Measure the resistance of the Transport Motor between each pin P/J8879-1/2/5/6 (Finisher Paper Transportation). The resistance is approx. 20 Ohm. Y↓ N→Replace the Transport Motor. Replace the Finisher PWB. If the problem persists, replace the Transport Motor. Check the Exit Roller, Entrance Roller, Paddle Shaft and Eject Belt for wear, damage or contamination (PL 23.13). Check the Compiler Exit Sensor and Transport Motor circuits for an intermittent condition. If the problem continues, replace the Finisher PWB.