Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.161 — Xerox Phaser 7800

Code: 312.161

Description: Finisher Set Eject Jam. After the Eject Motor turned On, the Compiler Tray No Paper Sensor did not turn Off within the specified time.
Remedy: Enter dc330 Component Control [012-151], Compiler Tray No Paper Sensor. Select Start. Actuate the Compiler Tray No Paper Sensor. The display changes. Y↓ N→Check the wire between J8880 pin 2 and J8894 pin 2 on the Finisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between J8894 pins 3 and 1 on the Finisher PWB (Set Eject Control (1 of 2)). The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between J8894 pin 2 on the Finisher PWB and GND (Tamping Control (2 of 2)). Actuate the Compiler Tray No Paper Sensor. The voltage changes. Y↓ N→Replace the Compiler Tray No Paper Sensor (PL 23.12). Replace the Finisher PWB. Alternately execute dc330 Component Control [012-054 Eject Motor FORWARD LO] and dc330 Component Control [012-055 Eject Motor FORWARD HI]. The Eject Motor starts up. Y↓ N→Check the wires between P/J8878 on the Eject Motor and P/J8893 on the Finisher PWB (Set Eject Control (1 of 2)) for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓ N→Repair/reconnect as required. Measure the resistance of the Eject Motor between each point of P/J8878-1/3/4/6 (Set Eject Control (1 of 2)). The resistance is approx. 20 Ohm. Y↓ N→Replace the Eject Motor. Replace the Eject Motor. If the problem persists, replace the Finisher PWB (PL 23.16). Check the Exit Roller, Entrance Roller, Paddle Shaft and Eject Belt for wear, damage or contamination (PL 23.13). Check the Compiler Tray No Paper Sensor and Eject Motor circuits for an intermittent condition. If the problem continues, replace the Finisher PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie