Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.162 — Xerox Phaser 7800

Code: 312.162

Description: H-Transport Exit Sensor On Jam. H-Transport Exit Sensor is not turned On within a specified time.
Remedy: • Check for obstructions in the paper path. • Check that the Finisher is dock correctly to ensure proper Transport Gate operation. • Check the H-Transport Motor Belt for wear or damage. • Check the Guides on the H-Transport Cover for damage, wear or faulty installation. • Check the Fuser Exit Switch actuator for damage, installed properly, or actuator spring damaged or missing.
Enter dc330 Component Control [012-191], H-Transport Exit Sensor (PL 24.6 Item 8). Select Start. Open the H-Transport Cover and actuate the H-Transport Exit Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Horizontal Transportation (2 of 2). Check the circuit of the H-Transport Exit Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [012-090], H-Transport Motor (PL 24.6 Item 21). Select Start. The motor energizes. Y↓ N→Select Stop. Go to Finisher H-Transport Drives. Check the circuit of the HTransport Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Check the following: • Ensure that the connectors shown in the circuit diagrams are securely connected and that the wires are not damaged. • Check the H-Transport Motor and its associated gears and belts for damage, contamination or misalignment. If the above checks are OK, then replace the H-Transport Exit Sensor (PL 24.6 Item 8). If the problem persists, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie