Code: 312.212
Description: Stacker Upper Limit Fault. When Stack Height Sensor 2 On was detected after the Stacker Tray had started lifting up.
Remedy: • The Upper Limit SW for improper installation. • The Upper Limit SW connectors for connection failure. • The Elevator Motor for operation failure. • The Elevator Motor connectors for connection failure.
Enter dc330 Component Control [012-061] Elevator Motor Down and [012-060], Elevator Motor UP (PL 24.31 Item 24), alternately. Select Start. The Elevator Motor runs. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Elevator Motor and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Elevator Motor. If the problem continues, replace the Finisher Main PWB. Select Stop. Select [012-262], Stacker No Paper Sensor (PL 23.7 Item 32). Select Start. Block/unblock the Stacker No Paper Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Stacker No Paper Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Stacker No Paper Sensor (PL 23.7 Item 32). If the problem continues, replace the Finisher Main PWB. Select [012-260], Upper Limit Sensor (PL 24.31 Item 17). Block/unblock the Upper Limit Sensor. Select Start. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Upper Limit Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Upper Limit Sensor. If the problem continues, replace the Finisher Main PWB. Select Stop. If the problem continues, replace the Finisher Main PWB.
Enter dc330 Component Control [012-061] Elevator Motor Down and [012-060], Elevator Motor UP (PL 24.31 Item 24), alternately. Select Start. The Elevator Motor runs. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Elevator Motor and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Elevator Motor. If the problem continues, replace the Finisher Main PWB. Select Stop. Select [012-262], Stacker No Paper Sensor (PL 23.7 Item 32). Select Start. Block/unblock the Stacker No Paper Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Stacker No Paper Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Stacker No Paper Sensor (PL 23.7 Item 32). If the problem continues, replace the Finisher Main PWB. Select [012-260], Upper Limit Sensor (PL 24.31 Item 17). Block/unblock the Upper Limit Sensor. Select Start. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Upper Limit Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Upper Limit Sensor. If the problem continues, replace the Finisher Main PWB. Select Stop. If the problem continues, replace the Finisher Main PWB.