Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.233 — Xerox Phaser 7800

Code: 312.233

Description: Puncher Move Home Sensor On Fault. Puncher Move Home Sensor is not turned On after the lapse of 400(300*500**)msec from operation start. Puncher Move Home Sensor is not turned on after the stop following Puncher Move Home Sensor On.
Remedy: • The Actuator for deformation • The Puncher Move Home Sensor for improper installation • The Puncher Move Home Sensor connectors for connection failure • The Puncher Move Motor connectors for connection failure
Enter dc330 Component Control [012-071] and [012-073], Puncher Move Motor (PL 24.32 Item 15), alternately. Select Start. The Puncher Move Motor energizes. Y↓ N→Select Stop. Go to BSD 14 22 Finisher Punch Drive. Check continuity between the Puncher Move Motor and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Puncher Move Motor (PL 24.32 Item 15). If the problem continues, replace the Finisher Main PWB. Select Stop. Select [012-270], Puncher Move Home Sensor. Select Start. Block/ unblock the Puncher Move Home Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Punch Hole Control. Check continuity between the Puncher Move Home Sensor and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Puncher Move Home Sensor. If the problem continues, replace the Finisher Main PWB. Select Stop. Check the following: • Puncher Move Motor rack and gear for binding, wear, or damage If the above check is OK, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie