Description: Puncher Move Home Sensor Off Fault. Puncher Move Home Sensor not turned Off after the lapse of 1000 (100*) msec from operation start. Puncher Move Home Sensor is not turned off after the Stop following Puncher Move Home Sensor Off.
Remedy: • The Actuator for deformation • The Puncher Move Home Sensor for improper installation. • The Puncher Move Home Sensor connectors for connecEnter dc330 Component Control [012-071] and [012-073], Puncher Move Motor (PL 24.32 Item 15), alternately. Select Start. The Puncher Move Motor run. Y↓ N→Select Stop. Go to BSD 14 22 Finisher Punch Drive. Check continuity between the Puncher Move Motor and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Puncher Move Motor (PL 24.32 Item 15). If the problem continues, replace the Finisher Main PWB. Select Stop. Select [012-270], Puncher Move Home Sensor. Select Start. Block/ unblock the Puncher Move Home Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Punch Hole Control. Check continuity between the Puncher Move Home Sensor and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Puncher Move Home Sensor. If the problem continues, replace the Finisher Main PWB. Select Stop. Check the following: • The Puncher Move Motor Belt for improper tension • The Puncher Move Motor Belt for disengagement If the above checks are OK, replace the Finisher Main PWB.tion failure • The Puncher Move Motor connectors for connection failure