Code: 312.243
Description: Booklet Folder Home Sensor On Fault. Folder Home Sensor is not turned on after the lapse of 500ms from Motor ON while Folder Knife is returning to Home.
Remedy: • The Folder Home Sensor for improper installation • The Folder Home Sensor connectors for connection failure • The Folder Knife Motor connectors for connection failure • The Knife drive mechanism for a foreign substance
Enter dc330 Component Control [013-022], Folder Knife Motor FWD and [013-023], Folder Knife Motor REV alternately. Select Start. The Fold Knife Motor energizes. Y↓ N→Select Stop. Refer to Folder Control. Check continuity between the Booklet Folder Knife Motor ( P/J8905) and the Finisher PWB ( J8985), and between the Booklet PWB ( P/J8994) and the Finisher PWB ( J8985). The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Booklet Folder Knife Motor (PL 23.15 Item 15). If the problem continues, replace the Booklet PWB. Select Stop. Enter dc330 Component Control [13-101], Folder Home Sensor. Select Start. Block/unblock the Folder Home Sensor. The display changed. Y↓ N→Check the wire between J8904 pin 2 and P/J8990 pin 2 on the FInisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between P/J8990, pins 3 and 1 on the Finisher PWB (Folder Control). The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between P/J8990, pin 2 on the Finisher PWB and GND (Folder Control). Block/unblock the Folder Home Sensor. The voltage changes. Y↓ N→Replace the Folder Home Sensor (PL 23.15 Item 16). Replace the Finisher PWB. If the problem continues, replace the Finisher PWB.
Enter dc330 Component Control [013-022], Folder Knife Motor FWD and [013-023], Folder Knife Motor REV alternately. Select Start. The Fold Knife Motor energizes. Y↓ N→Select Stop. Refer to Folder Control. Check continuity between the Booklet Folder Knife Motor ( P/J8905) and the Finisher PWB ( J8985), and between the Booklet PWB ( P/J8994) and the Finisher PWB ( J8985). The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Booklet Folder Knife Motor (PL 23.15 Item 15). If the problem continues, replace the Booklet PWB. Select Stop. Enter dc330 Component Control [13-101], Folder Home Sensor. Select Start. Block/unblock the Folder Home Sensor. The display changed. Y↓ N→Check the wire between J8904 pin 2 and P/J8990 pin 2 on the FInisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between P/J8990, pins 3 and 1 on the Finisher PWB (Folder Control). The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between P/J8990, pin 2 on the Finisher PWB and GND (Folder Control). Block/unblock the Folder Home Sensor. The voltage changes. Y↓ N→Replace the Folder Home Sensor (PL 23.15 Item 16). Replace the Finisher PWB. If the problem continues, replace the Finisher PWB.