Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.243 — Xerox Phaser 7800

Code: 312.243

Description: Booklet Knife Home Sensor On Fault. Knife Home Sensor is not turned on after the lapse of 500ms from Clutch On while Booklet Knife is returning to Home.
Remedy: Check the following: • The Knife Home Sensor for improper installation • The Knife Home Sensor connectors for connection failure • The Booklet Fold Motor connectors for connection failure • The Knife Clutch connectors for connection failure • The Knife Clutch for improper installation • The Knife drive mechanism for a foreign substance
Manually move the Booklet Tamper to both ends. Enter dc330 Component Control [013-008] and [013-009], Booklet Folder Roll Motor (PL 24.58 Item 2), alternately. Select Start. The Booklet Folder Roll Motor energizes. Y↓ N→Select Stop. Go to Booklet Drive. Check continuity between the Booklet Folder Roll Motor and the Booklet PWB and between the Booklet PWB and the Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Booklet Folder Roll Motor (PL 24.58 Item 2). If the problem continues, replace the Booklet PWB (PL 24.51 Item 1). If the problem persists, replace Finisher Main PWB. Select Stop. Select [013-010], Knife Solenoid, (PL 24.58 Item 10). Select Start. The Knife Solenoid actuates. Y↓ N→Select Stop. Go to Booklet Knife Control. Check continuity between the Knife Solenoid and the Booklet PWB and between the Booklet PWB and the Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Knife Solenoid (PL 24.58 Item 10). If the problem continues, replace the Booklet PWB (PL 24.51 Item 1). If the problem persists, replace Finisher Main PWB. Select Stop. Select [013-101], Booklet Knife Home Sensor (PL 24.54 Item 3). Select Start. Block/unblock the Knife Home Sensor. The display changed. Select Stop. Go to Booklet Knife Control. Check continuity between the Knife Home Sensor and the Booklet PWB and between the Booklet PWB and the Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Knife Home Sensor (PL 24.54 Item 3). If the problem continues, replace the Booklet PWB (PL 24.51 Item 1). If the problem persists, replace Finisher Main PWB. Select Stop. If the problem continues, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie